4. Turn the two hammer-head bolts on the burner to
vertical position.
Figure 11
5. Lift the prepared burner up obliquely and guide it
carefully into the bottom section. Fit the burner onto
the two pins (5, Figure 12) on the bottom section.
5
6
Figure 12
6. Insert the secondary air connection into the bottom
section through the opening in the side. As you do so,
pay attention that the sealing cord (6, Figure 12) is
seated correctly. Reattach the secondary air connection
to the burner – the screws should be located fully
inside the recess on the mounting plinth (secondary air
connection must be fully inserted).
7.
Press the burner firmly onto the bottom section. Press
the two hammer-head bolts against the bottom section
and turn them clockwise through 90°. This locks the
rear part of the bolt in position, and you can now
screw the burner to the bottom section using the nut.
i
Never turn the hammer-head bolts anti-
clockwise - turning them just a short
distance in anti-clockwise direction will
release them from their anchoring in the
bottom section!
8. Check that the burner is tightly seated on the
bottom section.
9.
To make it easier to fit the ash wiper ring, release screw
(9, Figure 13) and remove the ash wiper plate (9a).
10. Fit the front section of the ash screw (10) by inserting
the released screw into the rear screw located in
the bottom section. It can be positioned precisely by
holding the screw and guiding it by hand in the cavity
(Figure 13).
11. Reattach the ash screw (4, Figure 04) with the screw
bearing (4b).
12. Fit the ash wiper ring as follows:
- Turn the ash wiper ring so that the notch points
towards the recess on the burner plate. The recess
is located in the
baCk
of the combustion chamber.
- Place the ash wiper ring on the burner plate at
the front and press the wiper ring back towards
the recess.
- Test the ash wiper ring for ease of movement.
13. Using the screw (9), attach the ash wiper plate
(9a, Figure 13) as far as the lower stop of the bracket.
9
10
9a
Figure 13
11
4 211 326 / 01
InSTALLATIOn
Summary of Contents for 30-BioLyt 13
Page 53: ...53 4 211 326 01...
