horsch Leeb 6 GS, Operating Instructions Manual, Page: 28 / 154

28
1.13 Working in the vicinity of
high voltage power lines
Be extra cautious when working under or within
the range of high voltage power lines.
WARNING
Danger of electric accidents by touch-
ing high voltage power lines or voltage
transfer through the spraying boom.
¾
The total height of 4 m is considerably exceed-
ed when folding and unfolding the boom.
¾
The total height of 4 m can also be consider-
ably exceeded during field work .Assess the
situation before starting work!
¾
If you have to pass under overhead lines, you
must ask the operator of these overhead lines
about their rated voltage and minimum height.
¾
The safety distances in the following table must
under no circumstances be fallen short of:
Rated voltage Safety distance from
overhead power lines
KV m
Up to 1 1
1 to 110 2
111 to 220 3
220 to 380 4
1.14 Danger caused by
residual energy
Pay attention to the occurrence of mechanical,
hydraulic, pneumatic and electric/electronic
residual energies on the machine. Apply ap-
propriate precautions when instructing operating
personnel. You will find detailed information in
the corresponding chapters of the operating
instructions.
1.10 Impermissible operating
modes
The operating safety of the delivered machine
is only ensured in case of intended use as
specified in chapter 2.6 of these operating in -
structions.
The limit values specified in the data sheets must
under no circumstances be exceeded.
1.11 Spare parts and wear
items as well as auxiliary
materials
Machine parts in unacceptable condition must
be replaced immediately.
Use only original HORSCH LEEB AS spare parts
and wear items, to maintain the validity of the
type approval as per national and international
regulations.
When using spare parts and wear items from
third parties it cannot be ensured that these
have been designed and manufactured under
the aspects of expected loads and safety.
HORSCH LEEB Application Systems GmbH will
not assume liability for damage resulting from
the use of unapproved spare parts and wear
items or auxiliary materials.
1.12 Cleaning and waste
disposal
Handle and dispose of all materials and sub-
stances used for this purpose appropriately, es-
pecially when working on lubrication system and
facilities and when using solvents for cleaning.