horsch Leeb 5.280 VL, Operating Instructions Manual

Page: 71 / 308

Oil drain plug
Filling opening
NOTE
Oil level control:
¾
During operation the oil level must be between
min and max.
¾
Level for service: The oil level must be here
when refilling. Do not fill up further than to
the marked area. The machine must be in
the maintenance position.
Maintenance position: Ladder folded down,
steering centred, ClearanceControl at lowest
position, suspension centred, track width re-
tracted, folding boom folded in and put down.
Oil change
NOTE
Do not mix different oils. Use only the prescribed
specification!
Before changing the oil type, you should consult
the Customer Service.
We advise you not to use bio-hydraulic oils.
Should the use of bio-hydraulic oils be neces-
sary in isolated cases, you should strictly consult
the Customer Service.
Refer to the Maintenance chapter and the
HORSCH maintenance log for the first oil
change and the further intervals.
¾
Place a suitable collecting vessel under the
drain plug and on the drain hose.
¾
Open the drain plug and screw in the drain
hose.
¾
Drain oil into a suitable collecting vessel and
dispose of in accordance with regulations.
¾
Clo se the drain plug.
¾
Fill in new oil according to the maintenance
table. Follow the Maintenance overview section
in this regard.
¾
Check the oil level (oil must be visible in the
sight glass) (depending on variant).
¾
Start the engine and run it for two minutes at
idle speed.
¾
Set the hydraulic height adjustment to street
mode. (optional)
¾
Check oil level once more, top up if necessary.
NOTE
You may hear pump noises temporarily. If these
do not disappear after a short while, shut down
the engine and consult our After Sales Service!
66 67