Honeywell Vocollect, Hardware Reference Manual

Page: 222 / 316

| Chargers | 222
Number of
chargers
on rail
Minimum cut
lengths for rail
DIN rail specs Standard DIN rail
1 550 mm
2 1101 mm
3 1652 mm
Single unit length 550 mm; weight
331.5 g (11.6933 oz)
• Drill
• Fasteners
• Screw driver
1.
Install the DIN rail on the wall in the desired location. Ensure that the secure installation, supporting surface, and
mounting hardware will safely support the weight of a fully loaded charger, at 25 lbs. per linear foot (37.2 kg/m)
of DIN rail. Ensure that the anchor holes are at least 12 inches (30.5 cm.) from the floor. Verify that the installation
meets all local building codes.
2. Important: The power supply for the charger should already be zip-tied in the back of the charger
chassis. If it is not, plug the power supply into the charger and secure it. Do not plug it into a power source
until after mounting is complete.
Before attaching the charger to the rail, open the locking arms on the back of the unit by rotating the two levers
out on each side of the charger. The arms are parallel to the floor in the unlocked position.
3.
Attach the charger to the DIN rail by hanging the two hooks on the back of the unit on the top lip of the rail.
4. Slide the charger horizontally to the desired position on the rail, and rotate the locking arms into the locked
position - flush with both sides of the unit.
5.
If the charger does not feel secure on the rail, adjust the rubber stops on the back of the unit by screwing them out
toward the wall.
6. Plug the power supply into a power source and check the LED indicator at the bottom right of the charger face. If
the indicator light is a solid green, the charger is powered on.
A700 Battery Charger
Figure 153: A700 12-Bay Battery Charger
A700 12-Bay Battery Charger Specifications
Length 22.1" (56.1cm)
Depth 5.83" (14.8cm)