Honeywell Vocollect, Hardware Reference Manual

Page: 88 / 316

| Talkman A500 | 88
• The LED indicators flash orange as the devices attempt to connect to the network to listen for a file broadcast.
• The LED indicators flash green briefly as the devices receive profiles from the configured device and verify
the configuration.
• The LED indicators change to solid red as the devices reboot.
• When the devices have applied the configuration file and successfully contacted VoiceConsole, the LED
indicators change to blinking green. The devices are then ready to use or can be used in another charger to
bring additional devices online.
Note: The AC power indicator at the bottom right of the charger displays alternating green and yellow
lights when Easy Configuration operations are occurring. Devices should not be removed until the
individual indicator on the device blinks green or the charger's power indicator glows solid green.
Talkman A500 VMT
A Talkman A500 VMT is an A500 device with a battery adapter mounted to a vehicle, such as a forklift or motorized
pallet jack. After the device is mounted, the battery adapter is placed in the battery area of the A500 device and
connected to the vehicle’s power source.
Talkman devices in this configuration may use any wired or wireless equipment (headsets, scanners, etc.). Honeywell
sells the complete solution including mounting kits and power systems to enable any Talkman A500 devices to be
used in an A500 VMT configuration.
CAUTION: PLEASE DO NOT LOOK AT DEVICE/UNIT WHILE OPERATING MACHINERY SO
AS TO AVOID CREATION OF A DISTRACTION THAT COULD RESULT IN AN ACCIDENT AND
BODILY INJURY TO OPERATOR AND THIRD PERSONS.
Follow the instructions below to properly install the device in a forklift.
• Determine the best location for mounting the device, taking into consideration the driver’s field of view.
• Install the appropriate mounting hardware.
• Connect the device to the vehicle’s wiring system.
Mounts for Talkman A700/T5 VMT
The Screw On Mount is a mounting option that is bolted to a stationary surface on a vehicle.
The Clamp Mount is a mounting option that is clamped to a stationary surface on a vehicle. This can also be bolted to
a stationary surface, if desired.
The Claw Mount is also clamped to a stationary surface, but can be clamped to oddly-shaped or horizontal or vertical
surfaces.
Figure 29: Screw On Mount Figure 30: Clamp Mount
Figure 31: Claw Mount