Honeywell Vocollect, Hardware Reference Manual

Page: 61 / 316

| Talkman A700 | 61
• Cables should not be run such that they can get caught on moving parts.
• Cables should not be run on the outside of a vehicle.
• Cables should not have 90 degree turns, the minimum bend radius should not be less than one inch
• To remove slack on a cable it should be coiled up and secured inside the vehicle with a cable tie.
• Fuses should be located as close as possible to the power source.
• To protect the VMT from power surges and to perform voltage conversion a converter module is fitted
between the VMT and the forklift battery.
Assemble the Vehicle Battery Cable
1. Route the battery cable from the power supply to the vehicle battery.
2. Cut the battery cable near the battery leaving enough of the cable to reach the battery terminals.
3. Strip the battery cable jacket back 31 to 36 cm (12 to 14 in).
4. Install heat shrink tubing on the battery cable jacket.
5. Insert and secure the fuse in the fuse holder assembly.
6.
Assemble the negative wire:
1.
Strip 0.60 cm (0.25 in) of insulation from the green and white wires.
2. Twist the wires together.
3. Crimp a 3/8-inch terminal ring onto the wires.
7.
Assemble the positive wire:
1.
Cut a strip of red wire that is 5.08 cm (2 in) long.
2. Strip 0.60 cm (0.25 in) of insulation from the red and black wires.
3. Twist the wires together.
4. Crimp the fuse block assembly to the wires.
5.
Crimp the red wire you cut to the other end of the fuse block assembly.
8. Install heat shrink tubing on the braided ground wire.
9.
Crimp a 3/8-inch terminal ring onto the braided ground wire.
10. Connect the 4-pin connector to the power supply.