Honeywell Vocollect, Hardware Reference Manual

Page: 214 / 316

| Honeywell Wireless Headsets | 214
Parameter Supported
Devices
Description Values & Setting Location
SrxAutoPairEnable A700,
A500, T5-
Series
Enables automatic pairing mode
on SRX and SRX2 headsets.
This parameter is not applicable
for third-party handheld devices.
0 = disabled
1 = enabled
The default setting depends
on the version of Vocollect
Voice software implemented.
If this parameter is set to
1 (enabled), the setting of
SrxClearPairingInCharger is
ignored
Set in task package, operator
profile, device profile, or VRG
file
SrxClearPairingInCharger A700,
A500, T5-
Series,
Psion,
Intermec
Gives the user the ability to
force devices to clear the headset
Bluetooth pairing from memory
when placed into a charger.
If SrxAutoPairEnable is on, this
defaults to 1 as well to clear
pairings when placed into the
charger.
0 = disabled
1 = enabled
If you enable this parameter,
the SrxAutoPairEnable must
be set to 0 (disabled).
Set in VoiceConsole > Device
Profile
SrxHeadsetEnable A700,
A500, T5-
Series
Enables/disables use of SRX or
SRX2 wireless headsets with
approved Bluetooth devices.
Users may prefer to disable
headsets when using other
Bluetooth peripherals.
0 = disabled
1 = enabled
Set in VoiceConsole > Device
Profile
SrxHighPowerPairingDelaySeconds A700,
A500, T5-
Series,
Psion,
Intermec,
Motorola
SRX headsets : Specifies how
long (in seconds) an operator
is required to hold the plus and
minus buttons on an SRX headset
while in low power pairing mode
before entering high power
pairing mode.
SRX2 headsets : This parameter
specifies if the operator is
required to press the plus and
minus buttons on an SRX2
headset while in low-power
pairing mode to enter high-power
pairing mode.
SRX headsets : 1 to 10
seconds
(default is 6)
Value can be 0 when AutoPair
is enabled for headsets.
Set in VoiceConsole > Device
Profile
SRX2 headsets : 0 = the
headset enters high-power
pairing mode when the SRX2
headset is turned on.
any other setting = the
operator must press the plus
and minus buttons on an
SRX2 headset to enter high-
power pairing mode.
Set in VoiceConsole > Device
Profile