Honeywell S7999D1048, Manual

Page: 32 / 76

S7999D1048 COMBUSTION SYSTEM OPERATOR INTERFACE DISPLAY
65-0321—01 32
6. Quit
• Press this button when done with the curve at this
point. The following buttons display:
a. Back:
• Press to return to the Commission Configuration
screen.
b. Home:
• Go to Home page.
c. Finish:
• Press to save the profile you have created. The
Finish button is grayed out until you complete the
profile. After you press this button, the Monitor
screen is displayed. You can exit the program from
there.
d. Save:
• Save Curve S7999D flash (Fig. 60 and 61). Control
returns to Curve Commission screen.
e. Cancel:
• Cancel Quit and continue curve configuration.
The following screens depict the options possible to create or
change the profile curve for the currently selected fuel. The
operation of this screen is explained in the Commission Curve
screen, defined earlier.
Curve commissioning can only occur after all actuators have
been completely configured and locked. The Next button on the
Commission Configuration screen is not enabled until this is
true. Once the actuators are configured, the Next button brings
the user to the Curve Commissioning screen.
NOTE: The Load Curve button also brings the user to
this screen. It is also only enabled after the
actuators have been configured.
Fig. 56. Start lightoff.
Fig. 57. Purge setting on Commission.
Fig. 58. Commissioning—set lightoff.
Fig. 59. Commissioning curve—Delete points.