Honeywell S7999D1048, Manual

Page: 38 / 76

S7999D1048 COMBUSTION SYSTEM OPERATOR INTERFACE DISPLAY
65-0321—01 38
If the user chooses to remove the EEPROM image data from
the S7999D flash, the user selects the “Delete EEPROMs”
images button. The user is asked to confirm this action (Fig.
74) before proceeding.
Fig. 74. EEPROM Maintenance—Delete Images from
S7999D.
Load Profile Curve
A profile modulation curve stored in the S7999D can be loaded
for use as the active curve for commissioning. When the user
selects the “Load Profile Curve” button, the following screen
(Fig. 75) displays.
Fig. 75. Load Profile Curve.
A list of all defined profile curves is given. The user selects
which one to load and presses the “OK” button to load it. A
view of the curve can be seen before loading by pressing the
“View” button.
MONITORING
The Honeywell devices attached to the burner system are
represented by icon buttons on the Home page. To obtain
status information about each device, the user selects the
button that corresponds to the device. A new page displays
with status information exclusively about that device.
If any device is currently in a fault condition, the device icon is
displayed with a red color. Also, if audio alarm is enabled for
fault conditions (see User Preferences), an audio alarm sounds
while the fault continues to exist. To turn off the audio alarm,
the user must go to the device status page to view the fault
history or press the Alarm Silence icon on the Home page.
Burner Control (7800 SERIES)
Monitoring the 7800 SERIES burner control is performed by
clicking on the Burner Control icon on the Home Screen.
Status information similar to that displayed in Fig. 76 appears.
NOTE: Pressing the Home or Back buttons in the upper
corners of the screen will exit the status screen
and return to the Home page.
Fig. 76. Burner Control Status.