Honeywell S7999D1048, Manual

Page: 15 / 76

S7999D1048 COMBUSTION SYSTEM OPERATOR INTERFACE DISPLAY
15 65-0321—01
SETTING UP THE S7999D
DISPLAY
1. At Home Page, touch Setup Button. The Setup Page is
displayed.
Fig. 19. Setup Page.
2. At Setup Page, touch Display Setup Button. The Display
Setup Page is displayed.
Fig. 20. Display Setup Page.
3.
At Display Setup, touch Set Date/Time Button. The Set
Date/Time Page is displayed. On the “General” tab, the
Volume level (for touch audio feedback and alarm), Back-
light intensity, Sound alarm for faults, Installation type
(icon displayed [Burner system or Boiler system] when
IO is connected to a network of multiple burner/boiler
controls) can be adjusted.
Fig. 21. Set Date/Time Page.
4. Set the Date and Time and touch OK.
5. When the “Sound audio alarm for fault?” box is checked,
the internal speaker of the S7999D will be activated and
a 2-tone alarm will sound whenever a fault occurs in one
of the controllers connected to the S7999D. Use the vol-
ume slider bar to adjust the volume level. Also an “alarm
bell” icon will be displayed in the lower left hand corner of
the screen. (See Fig. 22). Touching the “alarm bell” icon
or touching the “OK” button, in the Fault dialog box will
turn off the S7999D audio alarm for the current fault.
Un-checking the “Sound audio alarm for fault?” box will
deactivate the audio alarm function.
Fig. 22. Home Page With Active Alarm.
6. Select Com 1 Tab to setup Com 1 port. In this example,
Com 1 has been setup for commissioning of the Contro-
Links R7999 F/A ratio controller (the baud rate will
default to 4800 baud, this baud rate is required to be able
to commission ControlLinks).