Honeywell OMNI 408, Installation And Setup Manual

Page: 15 / 104

4–1
S E C T I O N 4
System Operations
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
♦
Power-Up/System Reset
♦
Keypads
♦
Keypad Sounder
♦
Keypad Backlight Timer
♦
Keypad Addressing
♦
Arming the System
♦
Reset
♦
Bypass
♦
Subsequent Bypasses
♦
Quick Bypass
♦
Exit Bypass
♦
Auto Unbypass
♦
Manual Unbypass
♦
User Code Programming
♦
User Deletion
♦
Keypad Emergency Conditions
♦
Pager Follow-Me Displays
♦
Entering Pager Follow-Me Phone Numbers
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Power-Up/System Reset
When the system is in an armed state only, it may enter System Stabilization Mode. This occurs upon
power-up of the system, and causes all of the LEDs on the keypad(s) to light, and then go off for
approximately 2 minutes (if system was previously armed). This occurs on a total power-up or system
reset. If total system power is lost, upon power restoration, the system returns to the previous arming
state. The 2-minute, 10-second interval is used to allow motion detectors (in interior zones) to stabilize
on power-up in order to prevent false alarms. THIS OPTION CAN BE DISABLED BY PUTTING A
MOMENTARY JUMPER BETWEEN TERMINALS 15 AND 16 ON POWER-UP. IF DISABLED, THE
POWER-UP RESET TIME IS APPROXIMATELY 10 SECONDS. This is a normal condition.
Keypads
The OMNI-408 supports the following keypads:
OMNI-LCD Alpha Keypad
OMNI-LCD-US Alpha Keypad
STAY
BYPASS
INSTANT
CODE
1 2 3
4 5 6
7 8 9
*
0 #
XK-7LC_kypd
XK7LC Alpha Keypad