Honeywell OMNI 408, Installation And Setup Manual

Page: 102 / 104

OMNI-408/OMNI-408EU Installation and Setup Guide
F–2
NOTES:
1. 180mA max. for UL installations.
2. 650mA max. for UL installations.
3. Connect control panel to a grounded metal water pipe (16
gauge at 15 ft.).
4. Total aux. power available (including keypad power) is
500mA max. (180mA for UL and CSFM). Used for connection
of devices rated from 11.5 to 13.1VDC.
5. System must be tested on a weekly basis. For information
refer to this guide.
6. Do not connect the transformer to a switch-controlled
receptacle. In addition, for US installations, use an ADEMCO
No. 1321 transformer or for Canadian installations, use an
ADEMCO No. 1321CN transformer.
7. Installation of equipment and wiring methods must be in
accordance with the National Electrical Code and ANSI/NFPA
NO.74.
8. UL and CSFM require backup battery standby time of 24
hours minimum. Under normal conditions, this battery will last
3 years. Use only an exact replacement.
9. Maximum of 4 keypads allowed.
10. Limited-energy cable must be used.
11. Nonreplaceable fuse (F3). Return to manufacturer if blown.
Do not solder in field.
12. Maximum for UL installations: Entry Delay, 45 seconds; Exit
Delay 60 seconds.
13. Programmable trigger outputs.
14. Removing the ZR401, ZR402EU, or OMNI-RF will prevent RF
Programming. In addition, the RF Receiver for the OMNI-
408EU has not been evaluated by UL and must not be used
for UL installations.
RED BLACK BROWN
(+)
MODEL ESL2048
E.O.L. RELAY
( )
2 1
CONTROL PANEL
POWER
SMOKE
DETECTOR
9.5 - 12.2VDC
BROWN
CIRCUIT
(ZONE)
CONTROL UNIT
DELAY-SEC MODEL DELAY SEC
DETAIL A
ZONE
LISTED
HOUSEHOLD
THERMOSTAT
ESL 104
20
2.2k E.O.L.
RESISTOR
OMNI408-001-V0
SMOKE DETECTOR
UL LISTED
SMOKE
DETECTOR
MODEL ESL445AT
PRODUCT COVERED UNDER
US PATENT #4,791,658
25 26
4 3