40X ZOOM IR PTZ DOME CAMERA USER GUIDE
42
ARP/Ping
You can assign an IP address to the camera using the ARP/Ping service.
To enable ARP/Ping to set the IP address:
1.
Obtain an unused IP address in the same LAN as your PC.
2.
Write down the MAC address of the camera (it is listed on the label).
3.
Select the
Enable ARP/Ping
check box, and then click
Save
.
4.
Open the
Command Prompt
window on your PC (in Windows 7, click
Start
All Programs
Accessories
Command Prompt
) and type the appropriate
commands for your operating system:
5.
Reboot the camera. If the setup was successful, the Command Prompt
window will display “Reply from" and the IP address (for example, "Reply from
192.168.0.125 …”).
To verify that the IP address works, open your browser and type in the address
bar http:// followed by the IP address (for example, http://192.168.0.125),
then press Enter.
Configuring Port
You can configure network connections and port settings on the
Setting
Network
Port
Port
page.