Honeywell HDZ30A, User Manual

Page: 28 / 114

www.honeywell.com/security
28 | HDZ Series Analogue PTZ User Manual
Connecting RS485
Refer to Figure 2-6 and Table 2-5 when connecting a keyboard/controller to your camera
through the RS485 connection. Honeywell UltraKey Touch (HJC4000) is recommended for use
with the HDZ Analogue PTZ dome.
Figure 2-6 RS485 Connector
Connecting Video
You have two options for connecting to the video output port on the camera. The option that you
pick will depend on what type of cabling you are using for the installation:
• Coaxial cable (preferred method). Connect the coaxial cable to the camera’s BNC video
output port, and connect the other end of the cable to the video input port on your
monitor/switch/quad/mux/DVR.
• Unshielded twisted pair cable (UTP, optional). Connect the camera’s BNC video output
port to the optional UTP (unshielded twisted pair) balun accessory provided with your unit.
Connect one end of the unshielded twisted pair cable to the video input connection on
your monitor/switch/quad/mux/DVR and the other end of the UTP cable to the UTP balun
output connections.
The passive UTP balun included in the package is suitable for UTP transmission distances
of up to 100 m (328 ft). Please use an active UTP balun (not included with camera) for
transmission distances longer than 100 m (328 ft).
12 Pelco D 9600 None OFF OFF ON ON OFF OFF
13 Pelco P 2400 None ON OFF ON ON OFF OFF
14 Pelco P 9600 None OFF ON ON ON OFF OFF
a
The Maxpro Mode protocol is also compatible with Diamond protocol.
Table 2-4 Camera Control Protocol Switch Settings (cont’d)
Switch No. Protocol Baud Rate Parity
Switch Setting
SW1 SW2 SW3 SW4 SW5 SW6
1
2
3
4
5
Table 2-5 RS485 Pin Definitions
Pin Definition
1 R– (RS485–)
2 GND
3 R+ (RS485+)
4 T–
5 T+