Honeywell HDZ30A, User Manual

Page: 26 / 114

www.honeywell.com/security
26 | HDZ Series Analogue PTZ User Manual
Setting Dip Switches
When setting the dip switches for either the ID setting (see ID Setting on page 26 ) or camera
control protocol (see Camera Control Protocol Setting on page 27 ), see the following ON/OFF
positions as a reference (see Figure 2-3 ). Use the dip switch tool included with your unit to
change the dip switch position, as needed.
Figure 2-3 Dip Switch ON/OFF Positions
Configuring the camera’s ID and control protocol are required before connecting the camera to
other devices (see
ID Setting, page 26 , and Camera Control Protocol Setting on page 27 ).
Additionally, the 22-pin connector for data cable connection and ISP connector for firmware
upgrade kit connection are also set on the back plate (but not shown in
Figure 2-2 or Table 2-2 ).
ID Setting
Assign an ID number to a HDZ Series PTZ dome camera if there is more than one camera in the
same system. The camera’s ID can be set by using the 10-bit ID dip switch (see
Figure 2-4 ),
which is located on the camera’s back plate. If the camera’s ID number is 6, for example, the ID
switches SW2 and SW3 should be set to ON, and the rest should be set to OFF (see
Table 2-3
for ID settings). ID numbers 0–10 are listed in Table 2-3 . For a full list of possible ID numbers,
refer to Appendix C, ID Settings on page 97 .
Figure 2-4 ID Setting Dip Switches
Note No two cameras in a network should be given the same camera ID. A
communication conflict may occur.
ON ON
Switch is
set to ON. Switch is
set to OFF. Means switches 1,
2, and 3 are set to
ON, and switch 4 is
set to OFF.
Table 2-3 ID Switch Settings
ID
No.
Switch Setting
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 SW9 SW10
0 OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF
1 ON OFF OFF OFF OFF OFF OFF OFF OFF OFF
2 OFF ON OFF OFF OFF OFF OFF OFF OFF OFF
3 ON ON OFF OFF OFF OFF OFF OFF OFF OFF
4 OFF OFF ON OFF OFF OFF OFF OFF OFF OFF