Honeywell HDZ30A, User Manual

Page: 34 / 114

www.honeywell.com/security
34 | HDZ Series Analogue PTZ User Manual
Installing a Parapet/Flat Roof Mount
The HDPRM2 parapet/flat roof mount weighs 22.5 lb. (10.2 kg) and can be installed directly to
a vertical (parapet) or horizontal (flat roof) load-bearing surface. The mount has a maximum load
rating of 20.1 lb. (9.1 kg) and can be installed indoors or outdoors. The mount can withstand
winds up to 75 mph (121 km/h) when properly fastened to a support structure. See the
documentation included with the parapet mount for more information on securing the mount to
the mounting surface.
Figure 2-12 HDPRM2 Parapet/Flat Roof Mount Installation
6. Connect the cables to the camera (see Dip Switches and Cable Connections on page 25 ).
Connect the video output port either to a coaxial cable (with BNC connection) or with
optional UTP balun accessory if unshielded twisted pair cabling is used.
Note Check that the eyelet safety cable connection is secure, and carrying all of the
load of the camera after making all cable connections.
7. Attach the camera to the mount kit and then tightly fix the security screw on the top of the
camera.
To install a roof mount:
1. Ensure that the mounting surface can
support the combined weight of the
camera and the mount (should support
at least 28.2 lb. [12.8 kg]).
2. Feed the cables through the mount,
leaving approximately 1 ft (0.3 m)
extending past the end of the mount.
Note If you are using the recommended
safety cable for additional security,
feed it through the mount and attach
one end to the camera eyelet and the
other end to the building structure
(see
Figure 2-9 ).
3. Attach the mount to the mounting
surface using as many of the mounting
holes as possible (a minimum of five
fasteners on each side of the mounting
plate is recommended).
4. Apply sealant (not supplied) to the
bottom of the vertical pipe and around
the bolt holes to prevent water or other
contaminants from entering the mount.
5. Feed the cables through the mount kit
and screw the mount kit into the
parapet/flat roof mount.
Screw the mount kit
into the parapet mount
Attach the
camera body to
the mount kit
Tightly fix the screw at the top
of the camera after connecting
the three parts
Example of
Outdoor Dome
Parapet Mount
Installation
Feed cables through
the mount kit