Honeywell HDZ30A, User Manual

Page: 61 / 114

Operation and Configuration | 61
800-16526 - A - 07/2014
Figure 4-11 PT Position Options
Setting PT Display
Turn this item to ON to display the pan/tilt position on the screen. The display format will be
PXXX, TYY
.
Setting Pan to Zero
By using the SET PAN ZERO function, users can set the north direction as coordinate zero.
The display will show eight different directions including N, E, S, W, NE, SE, SW, NW depending
on the closest direction the Analogue PTZ Dome faces. The PAN range is from 0° to 359°, and
the TILT range is from 10° to -90°. After lower than -90°, the PAN degree will be automatically
added 180°.
Press TO SAVE to save the pan zero setting.
Exiting the PT Position Menu
Exit the PT POSITION and go back to SETUP MENU 2 and carry on setting other camera
functions.
Setting the Speed By Zoom
If Speed By Zoom is set to ON , the pan/tilt speed will be automatically adjusted by an internal
algorithm when zooming. A larger zoom ratio leads to a lower rotating speed.
Setting the Auto Calibration
There is one horizontal point and one vertical infrared rays check point in each dome. During
installation or maintenance, the Analogue PTZ Dome’s position may be moved. Therefore, the
relative distance between the original set point and the check point might have changed. If the
Auto Calibration function is enabled, the HDZ Series Camera will automatically detect the matter
and reset the horizontal point back to its original position.
Setting the Password
The administrator can activate an OSD Password for security concerns. Once the function is
enabled, users are required to enter the password every time they access the OSD menu. The
Password setting menu is shown in
Figure 4-12 .
PT POSITION
PT DISPLAY OFF →
SET PAN ZERO PT MOVE ↓
EXIT+SET YES