Address allocation
&
Always power-up with the mains supply
first and then connect the battery. The power-down
sequence should be in the reverse order.
Connecting Loop 1 circuit
&
Ensure the panel is powered down first
before connecting the external loop cables to the
panel.
It is recommended that each external circuit is wired up to the
terminals at the panel, one circuit at a time and tests conducted
to ensure that each circuit is functioning correctly. We start by
connecting End 1 only.
With Loop 1 End 1 connected
¨
Ensure
end-2 of the loop cable remains
disconnected
.
¨
Connect the mains and battery supply to power up the
panel, you will initially see the powering up messages.
If there are no device address allocation faults the
panel will start the loop.
Allocating Loop n
Allocation: OK at Card X : Allocated Y
Starting Loop n
Loop started OK at Card X: Started Y
¨
Even if all the devices are wired correctly and there are
no allocation faults, there may still be some device
faults, like mains and battery disconnected at interface
units, these will be displayed at the panel. The panel
fault buzzer
will sound and the Fault LED will be lit.
¨
To stop the local buzzer from sounding press
Cancel Buzzer
button.
"
In practice there may be system wiring and
hardware faults during the address allocation stage,
these faults are also displayed as messages and for
further information on what they mean and possible
action that can be taken, see Appendix B - Message
action.
4188-856_i2_12/06_Generic Vigilon (C VA) Comms.
41
Vigilon (EN & BS) Compact (VA) panels
Address
allocation
1
2
3
4
9
10
11
12
5
6
7
8
13
22
23
24
25
14
30
31
29
28
21
15
32
27
26
20
19
18
17
16
CONTROL PANEL
Main
loop
circuit
Spur
on
main
loop
Spur on main loop
END 1
Note: The End 2 connection is
not made at this stage of commissioning
Spur
on
main
loop
Previous
Next