Honeywell BENDIX/KING KLN 94, Pilot'S Manual

Page: 218 / 284

6.3.2. SELECTING A STAR
The steps required to select a STAR are very similar to those required to
select a DP. The only difference is the order of the steps to define the
STAR and where the STAR is loaded into the flight plan. The steps
required to define the Glen Rose Five arrival (coded JEN5) with the Wink
transition serve as an example of how to select a STAR. This STAR is to
the Dallas/Fort Worth International airport (KDFW).
To select a STAR:
1. Make sure the arrival airport, KDFW, is in FPL 0 or is the direct to
waypoint.
2. Press the
P
button to display
the PROC 1 page. Turn the
right outer knob counter-clock-
wise to position the cursor over
Select Arrival? (figure 6-65).
3. Press
F
to display the PROC 2 page.
NOTE : Normally, the desired arrival airport will already be displayed with
the cursor on it. In case it is not, move the cursor over the desired airport
or, if necessary, enter the airport identifier in the blank field on the page
and press
F
once to bring up the waypoint page for the airport and a
second time to approve it. If an airport is entered that doesn’t have a
STAR the scratchpad message
No STAR at APT will be displayed.
4. With the cursor over KDFW,
press
F
. The APT 7 page for
KDFW is displayed showing a
list of STARs for KDFW (figure
6-66).
5. Rotate the outer knob to move
the cursor over
JEN5 (figure 6-
67). Press
F
.
6. The KLN 94 will now ask which
transition you want to use. For
this example we want INK so
move the cursor over
INK (fig-
ure 6-68). Press
F
.
7. In cases such as this one, the
STAR procedure requires you
to select a specific runway. In
this example we will land on
Chapter 6 Approaches and DP/STARs
6-42
Figure 6-66
Figure 6-67
Figure 6-68
Figure 6-65