Honeywell BENDIX/KING KLN 94, Pilot'S Manual

Page: 132 / 284

4.2.5. VIEWING DISTANCE, ETE, ETA, OR DESIRED TRACK TO
FLIGHT PLAN WAYPOINTS
The right side of the active flight plan (FPL 0) page may be used to display
(1) the cumulative distance (
Dis ) along the flight plan route from the pre-
sent position to each flight plan waypoint, (2) the estimated time en route
(
ETE ) to each waypoint, (3) the estimated time of arrival ( ETA ) at each
waypoint, or (4) the magnetic desired track ( DTK ) for each waypoint.
If you have more than five waypoints in FPL 0, you may wish to view flight
data for waypoints which are not displayed on the screen. If this is the
case, turn on the cursor (
B
) and use the right outer knob to scroll down
the flight plan until the waypoint of interest is on the screen.
This display will default to the distance ( Dis ) presentation at power-on (fig-
ure 4-45).
To change between distance, ETE, ETA, and desired track on the
FPL 0 page:
1. Turn on the cursor with the
B
button; it will come up initially
over the distance
(Dis ) field.
2. Turn the right inner knob to
change the field from distance
(
Dis ), to ETE in hours:minutes
(figure 4-46), to ETA in terms of
the system time zone (figure 4-
47), to
DTK (figure 4-48) and
then back to Dis . Note that the
system time zone abbreviation
(e.g.
CDT ) is used to annunciate
when ETA is selected.
3. Press the
B
button to turn the
cursor off.
NOTE : When the KLN 94 is in OBS
mode, the FPL 0 page will present
OBS selected course (
OBS ) as an
option instead of magnetic desired
track (
DTK ). The selected course
will be displayed to the right of the
active waypoint, and the
OBS fields
for all other waypoints will be blank
(figure 4-49).
Chapter 4 Flight Plan Operation
4-14
Figure 4-47
Figure 4-46
Figure 4-48
Figure 4-49