Honeywell BENDIX/KING KLN 94, Pilot'S Manual

Page: 124 / 284

position automatically jumps
down to the next position. In this
case,
SJI automatically moves to
waypoint 3 and KPIE changes to
waypoint 8 (figure 4-15).
4. Complete the waypoint entry
operation (figure 4-16).
NOTE : If adding a waypoint or way-
points (such as adding DP/STAR/
Approach procedures) would exceed
the capacity of FPL 0, KLN 94 will
notify you that it is deleting waypoints
from the beginning of FPL 0 to make
room for the addition.
5. Press
F
to display the way-
point page on the right side for
the identifier just entered (figure
4-17).
6. Press
F
again to approve the
waypoint page (figure 4-18).
7. Turn off the cursor (
B
).
4.1.5. DELETING A WAYPOINT FROM A FLIGHT PLAN
To delete a waypoint from a flight plan:
1. Press
B
to enable the cursor if it is not on already.
2. Move the cursor over the way-
point you wish to delete (figure
4-19).
3. Press
E
. The letters Del
(delete) will appear to the left of
the identifier and a question
mark will appear to the right of
the identifier (figure 4-20). If a
mistake was made and you do
not wish to delete this waypoint,
press
E
.
Chapter 4 Flight Plan Operation
4-6
Figure 4-15
Figure 4-16
Figure 4-17
Figure 4-18
Figure 4-19
Figure 4-20