Honda EU3000i Handi, Manual

Page: 178 / 194

CYLINDER BLOCK
15-13
CRANKSHAFT BEARING/OIL SEAL
REPLACEMENT (CYLINDER BARREL
SIDE)
LOCATION
CRANKSHAFT BEARING (6205)
Remove the crankshaft, crankshaft oil seal (page 15-4).
Drive out the radial ball bearing.
Apply oil to the circumference of a new bearing (1).
Drive the radial ball bearing until it is fully seated on the
end using the special tools.
CRANKSHAFT OIL SEAL (25 x 41 x 6
mm)
Remove the crankshaft (page 15-4).
Remove the crankshaft oil seal.
Apply grease to the lip of a new oil seal (1).
Drive the oil seal in the position as shown using the
special tools.
CRANKSHAFT BEARING (6205)
CRANKSHAFT OIL SEAL (25 x 41 x 6 mm)
TOOLS:
Driver handle, 15x135L (2)
07749-0010000
Bearing driver attachment, 52x55
(3)
07746-0010400
Pilot, 25 (4) 07746-0040600
(3)
(2)
(4)
(Circumference)
(1)
TOOLS:
Driver handle, 15x135L (2)
07749-0010000
Bearing driver attachment, 37x40
(3)
07746-0010200
(Lip)
(1)
(3)
(2)
1.5 mm
(0.06 in)