Honda EU3000i Handi, Manual

Page: 170 / 194

CYLINDER BLOCK
15-5
PISTON DISASSEMBLY/ASSEMBLY
Remove the crankshaft (page 15-4).
MARK (TOP/
SECOND RING)
TOP RING
PISTON RINGS
ASSEMBLY:
Be sure that the top ring and second rings are not
interchanged.
Install the top ring and second ring on the piston
with the maker mark side facing up.
Check that the piston rings rotate smoothly after
installing them.
Space the piston ring end gaps 120 degrees
apart, and do not align the ring end gaps with the
piston pin bore.
SECOND RING
OIL RING
(COMBINATION
RING)
TOP RING
SECOND RING
OIL RING
(COMBINATION
RING)
SIDE
RAIL
SPACER
PISTON PIN
PISTON PIN CLIP (2)
ASSEMBLY:
Do not reuse. Install by setting
one end of the piston pin clip in
the groove of the piston pin bore,
holding the other end with needle
nose pliers, and rotating the clip
in.
Do not align the end gap of the
piston pin clip with the cutout of
the piston pin bore.
(Big end inner
surface and small
end inner surface)
CONNECTING ROD
ASSEMBLY:
Set the connecting rod with
the long end toward the mark
on the piston head.
PISTON
120°
10 mm (0.4 in)
120°
120°
10 mm (0.4 in)
LONG END
PISTON PIN CLIP
END GAP
CUT OUT
(Circumference)
PISTON
MARK