Hologic DISCOVERY A, Technical Manual

Page: 256 / 274

A-10
Error closing optical file ________________
Error flushing optical file _______________
Error writing optical record ____________
Hardware There is a problem writing an optical file. Either the medium is full, or there is a
hardware malfunction.
Action: Check for disk full. Go to DOS, type DIR D: and check for free space.
If the disk is not full, call Hologic Technical Support.
Error copying file _________ Hardware There was an error copying the named file.
Action: Verify that there was space on the target drive. Check the "Room for .. "
message in the status window. Run appropriate diagnostics.
Error creating file ______________ _________________
Hardware
or
Software
There is a problem creating a new file (which may be on your hard drive, your diskette,
or your optical). Either the medium is full, or there is a hardware error.
Action: First determine which disk drive is involved. The filename should start with a
drive letter, followed by a colon. Drive A: is diskette, C: is hard drive, and D: is the
optical.
Check for disk full. For diskette, simply try a different diskette and see if the problem
goes away. For hard drive, check the "Room for ___" message in the status window.
For optical, type DIR D:.
If the disk is not full, run appropriate diagnostics.
Error initializing graphics module. Action: This can be caused by not enough available memory or an incorrect graphics
adapter. Verify that only Hologic software is installed on the system and that the
graphics adapter has not been modified.
Error in region of interest structure Software Action: This message should be reported to Hologic Technical Support. Include as
much information as possible about what you were doing at the time.
Error opening the flattening input file
Error reading flattening configuration record
Action: Disk error or missing software. Check operation of hard disk, and check
consistency of system software with CHEKPART.
Error reading flattening factor record Action: Most likely cause is no flattening done for given scan mode. Re-run BIGFLAT.
ERROR MESSAGE
HARDWARE
/SOFTWARE
ERROR
LOCUS COMMENT/ACTION