Hologic DISCOVERY A, Technical Manual

Page: 253 / 274

A-7
Motor_TZ Comment: The TZ system is in service mode; the pedestals are moving and an
application attempts to move them in the opposite direction; or the TZ system is
performing a calibration.
Action: Verify that the TZ board service mode switch is in the off position.
Note: If you change the service mode switch position on the TZ board, you must reset
the TZ microprocessor before the new switch position takes affect. Otherwise,
report this error to Hologic Technical Support.
Device has not been configured [E_NOT_CONFIGURED_I] Comment: Invalid motor calibration data has been sent to the driver (e.g., one or more
of the motor calibration parameters–number of steps, step distance, number of ticks or
tick distance–is less than or zero).
Action: Verify that the system has been properly calibrated and the normal Hologic
system startup procedure has been followed (i.e., reboot the machine and if the
problem persists, recalibrate the motor).
Device is in emulation mode [E_EMULATE_I Comment: The device is in emulation mode. This is not an error but a report of the
device driver internal state. Some QDR 4500 models normally run with emulation
enabled for the devices that are not installed (e.g., the 4500W does not support the AR
device).
Action: None.
Device not ready to perform requested action [E_NOT_READY_I
STATE Comment: An application attempted to execute a state machine but the state machine is
not ready to execute because one or more of the necessary data structures has not been
downloaded (program or task table).
Action: Report this error to Hologic Technical Support.
ERROR MESSAGE
HARDWARE
/SOFTWARE
ERROR
LOCUS COMMENT/ACTION