29
• Make sure that the chest and shoulder pad is positioned
symmetrically on the pelvis and close the buckles on the lower
straps.
• Set the upper body of your child upright against the back.
• Finally, tighten the upper straps behind the seat and close the
buckles on the upper straps.
The fit and position of the harness is correct when the straps are not
touching the child and when the beaded edge of the harness is not in
contact with the strap guide slot.
The harness provides the best upper-body support when the strap
guide slot is approx. 2-3 cm above the child’s shoulder.
5.17 Abduction block
• Take off the seat upholstery to mount the clamping set.
• Plug the window strip on the rear side of the seat plate into the
borehole so that the thread of screw protrudes.
• Plug the two washers on the thread of screw and screw the wing
nut as shown in the illustration.
• Reset the seat upholstery.
Insert the abduction block with its flat link (A) through the slot in the
front part of the seat upholstery into the slot in the very front of the
seat plate so that the flat link (A) protrudes as shown.
Clamp the abduction block by turning the wing nut of the clamping
set.
5.18 Grab rail with upholstery
Insert the longer part of the grab rail into one side of the accessory
bracket of the seat unit. Make sure that the snap buttons point
towards the front.
Insert the shorter end into the other side of the accessory bracket
while pressing the snap button.
A
