27
Thread the attachment straps of the groin strap between seat and
back padding, wrap them around the back of the seat edge and
attach with carriage bolts and knurled nuts of the hip pads.
The set of holes allow a length adjustment.
To put on the groin strap proceed as follows:
• Place your child into the pushchair on the groin strap.
• The part of the thigh belt with the buckle attached should lie on the
pelvic bone.
• Insert the male part of the quick-release buckles located on the
tensioning straps into the buckles on the thigh belts.
• Tighten the thigh belt by pulling the free end of the strap that
comes out of the buckle.
• To disengage the quickrelease buckle, press the key on the buckle.
5.15 Fixation jacket
To attach the fixation jacket straps, rivet (from inside to outside) the
six cam-lock buckles to the outside of the back plate.
Thread the shoulder straps of the fixation jacket through the shoulder
slots to the rear. The centre “axillary straps“ must be threaded at the
appropriate height between the back frame tube and back plate.
Thread the lower straps through the slots in the lower part of the
back base (see also 5.8 lap belt) to the rear.
Thread all straps through the open cam-lock buckles and clamp in
position by closing the hinged cam.
Caution!
Excess strap ends on accessories may be trapped
between the two parts of the seat mounting interface
and prevent a full engagement of the lock pin. In such
a case the seat could fall off the mobility base. Shorten
excess strap ends on accessories so that they can not be
trapped.
Opening the fixation jacket:
• Open the quick-release buckles on the shoulder part of the fixation
jacket
• Pull the zipper down and open the fixation jacket.
• Lift your child out of the seat.
