Hobby Vantana 2018, Manual

Page: 70 / 207

7. Electrical Installations 69
TFT-Controlpanel
Functions of the main switch
The system consists of control electronics, a TFT control pa -
nel with a keypad and several 3-key control panels. It enables
you to operate the different lamps and several 230 V devices.
Furthermore, various kinds of information and measured values
are shown on the TFT display.
• Once the system is in operation, press the main switch briefly
to turn all of the lights off. All 12V steady electrical devices
(e.g. water pump, refrigerator , heating and entrance step) will
remain activated. The devices that were previously switched
on are stored in the system; pressing on the main switch
reactivates them. This also resets the degree to which those
lights were dimmed that can be regulated.
• Pressing the main switch for at least four seconds while the
system is switched on will turn off not only the presently
activated devices, but also the entire 12 V sockets (this also
affects the toilet flush and the water pump). The current
operating states will not be saved
.
• Briefly press the key to switch each lamp on and off. Press
longer on the key to regulate how brightly you want the
lights to shine. The brightness you set will be saved; when
the lights are switched on again, the brightness you origi
-
nally set will also be switched on again. If the system's
power supply is interrupted, the wall light will shine full
strength the first time you switch it on. If the intensity has
been reduced to a minimum by dimming the lights, the lamp
will switch itself off. Since this setting is saved, the dimmer
must be reset to the brightest level before the lamp will shine
again. For technical reasons, if the lamp is set to the very
lowest dimmed level, the light may flicker. If this bothers you,
please increase the intensity of light.
Lighting in the
seating arrange-
ment
Ceiling Lamp