E3 - 13
5.4
Stabilizer
Important:
With this adjustment, write the camera shake correction data stored in the adjustment floppy disk to EEPROM:
This data is the average of adjustment values obtained by adjusting at the factory production line.
(1) Stabilizer Adjustment
Incompleted Phenomenon:
The electronic image stabilizer does not operate normally.
Procedure:
1)
Input D to PC on the main menu screen.
2)
The screen for verifying writing of stabilizer data will appear: Input Y. (*1)
3)
When writing data is complete, the stabilizer data write complete screen will appear: Press any key to restore the main
menu screen.
*1:
Entering N on the screen for verifying writing of stabilizer data will restore the main menu screen.
5.5
Spot Noise
Important:
Spot noise refers to bright points that appear on the screen, which are caused by a defect in pixel of CCD image sensor.
Perform this adjustment after specified components have been replaced (see “List of Adjustment Items”).
Perform this adjustment if spot noise occurs under abnormal usage conditions or after long-term use.
If spot noise still occurs after this adjustment is complete, the CCD image sensor may be defective.
Perform this adjustment after completing all other adjustments. (Perform this adjustment in normal video status.)
(1) Spot Noise Adjustment
Incompleted Phenomenon:
Spot noise occurs under abnormal usage conditions or after long-term use.
Equipment:
Color video monitor (CRT type is desirable)
Condition:
Cap the lens (so that no light enters).
Main menu
***********************************************************
MANUAL ADJUSTMENT PROGRAM
***********************************************************
[A]
DATA INITIALIZE
[B]
ADJUSTMENT
[C]
AUTO FOCUS
[D]
STABILIZER
[E]
SPOT NOISE
[ESC] END
Please select [A] - [E] or [ESC]
<< DATA WRITING >>
START TO SEND DATA. (Y/N)
FINISHED WRITING DATA
PRESS ANY KEY
Screen for verifying write of stabilizer data
Stabilizer data write complete screen
PC Display & Figs
