E2 - 16
3.10 Eye Control, EVF-F Case, Plate-F, EVF-B Case, EVF LCD, EVF Backlight, EBL Circuit
Board (Fig. 3-10)
Cautions when disassembling:
Do not disassemble any of the components inside the eye control.
Do not subject the EVF LCD and EVF backlight to impact or allow them to be damaged.
Be careful that no foreign object, such as dust, enters the eye control.
Be careful not to damage any of the connector cables (flat cables).
3.10.1 Eye control (A)
(1) Remove the two screws holding the eye control (A).
3.10.2 EVF-F case, Plate-F (C)
(2) Remove the two screws holding the EVF-F case (B).
(3) While widening the EVF-F case (B), remove it in the direction of the arrow.
(4) While widening plate-F (C), remove it in the direction of the arrow.
3.10.3 EVF-B case (D), EVF LCD (E), EVF backlight (F), EBL Circuit board (K)
(5) Insert tweezers, etc. into the hole in EVF-B case (G), and while widening the tab of EVF-B case, remove the LCD
holder (H): Be careful not to damage the cable, etc. at this time.
(6) Release the two tabs, and remove the BL cover (I) from the LCD holder (H).
(7) Release the two tabs, and remove the BL plate (J) from the LCD holder (H).
(8) Disconnect two flat cables on the EBL circuit board (K).
A
B
C
H
F
D
E
J
I
(6)
(7)
(2)
(2)
(3)
(4)
(1)
(8)[Type-d]
(8)[Type-b]
G
K
(5)
Fig. 3-10
A :
Eye Control
B :
EVF-F Case
C :
Plate-F
D :
EVF-B Case
E :
EVF LCD
F :
EVF Backlight
G :
Hole in EVF-B Case
H :
LCD Holder
I
:
BL Cover
J :
BL Plate
K :
EBL Circuit Board
