Hitachi 46W500, Training

Page: 149 / 162

DP-36 CHASSIS ADJUSTMENT SPECIFICATION CHANGES.
CORRECTION for DP-36 LOUD POP AT TURN ON WHEN ON ANTENNA C
(1) Enter Adjust Mode OSD
With Set Off, Press [
POWER
] and [
INPUT
] on the Control panel.
When High Voltage is Heard, release both buttons. Service Menu appears on screen.
POWER + Input
ADJUST MODE XXXXXX
SERVICE
SUB BRIGHT
WHITE BALANCE
G DRIVE(HIGH)
R DRIVE(HIGH)
R CUTOFF(HIGH)
G CUTOFF(HIGH)
B CUTOFF(HIGH)
H POSITION
V POSITION
FACT RESET
**
**
**
**
**
**
**
(2) E2PROM Edit Mode is on the Adjust Mode 2
nd
page.
•
Thumbstick down below
FACT RESET
to reveal
the 2nd page of the Service Menu.
•
Highlight
E2PROM edit
and press the Thumbstick
Right button to reveal the
E2PROM edit
menu.
•
Change Address by Thumbstick Up / Down but-
ton.
•
Change Data by Thumbstick Right / Left button.
•
Press
SELECT
button to set data after each and
every change.
Thumbstick Down
To 2
nd
page.
SUB CNT
OSD
AFC
MEMORY INT
I2C OPEN
P MODE ADJ
E2PROM edit
ADJUST MODE
**
ADDRESS
DATA
E2PROM edit
**
**
Thumbstick down and Select
E2PROM edit
and Press The Thumbstick
Right
→ Button.
E2PROM Menu appears.
After making Data changes,
Press
EXIT
key to return to
main Service Menu.
(3)
EEPROM EDIT DATA CHANGES
Refer to ROM Correction Data Table on 2
nd
page
Thumbstick down to locate only the addresses that have data shown in the table on the 2
nd
page and make Data changes according to the Table for each address.
Press
Select
after each and every change in data value.
(4)
ROM CORRECTION
After making all corrections to Data. *Refer to Rom Correction Data Table on page 2.
Exit the EEPROM Edit Menu by pressing EXIT button.
Exit the Service Menu by pressing the EXIT button.
Unplug set then reapply AC power to execute
ROM CORRECTION
.
•
Change Address by Thumbstick Up/Down button.
•
Change Data by Thumbstick Right/Left button.
•
Press SELECT button to set data after Each and
every change in Data.
Page
10-15