Press Key to Enter Card Number
If you enable this function, you can input the card No. by pressing the key.
Wi-Fi Probe
If you enable this function, the device can probe the surrounding communication devices'
MAC address and upload the MAC address to the system. If the MAC address match the
specified MAC address, the system can trigger some linkage actions.
3G/4G
If you enable this function, the device can communicate in 3G/4G network.
NFC Anti-Cloning
If you enable this function, you cannot use the cloned card for authentication and further
enhance security.
4. Click OK.
5. Optional: Click Copy to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Configure Parameters for Door/Elevator
After adding the access control device, you can configure its access point (door or floor)
parameters.
Before You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced Function → Device Parameter .
2. Select an access control device on the left panel, and then click to show the doors or floors of
the selected device.
3. Select a door or floor to show its parameters on the right page.
4. Edit the door or floor parameters.
Note
• The displayed parameters may vary for different access control devices.
• Some of the following parameters are not listed in the Basic Information page, click More to
edit the parameters.
Name
Edit the card reader name as desired.
Door Contact
You can set the door sensor as remaining closed or remaining open. Usually, it is remaining
closed.
Exit Button Type
DS-K5604A-3XF Series Face Recognition Terminal User Manual
106
