Installation & Adjustments
Synergy 0.5 Turntable Stretch Wrapper Operation Manual
Highlight Industries, Inc. ● 2694 Prairie SW, Wyoming, Mi 49519 ● 1-800-531-2465
13
Receiving and Inspections
The Synergy Turntable Stretch Wrapper has gone through quality control tests at the
factory before shipment. Upon receiving, please do the following:
1. Inspect the entire machine for visual damage during shipment. If found, immediately
report this damage to the trucking line.
Highlight Industries, Inc.
has taken every
precaution during the packaging and loading of this equipment, however, it is YOUR
RESPONSIBILITY to inspect for damage before installation.
2. Make sure the part or serial number indicated on the machine corresponds with the
part number of your order.
Positioning of the Machine
Place the Synergy Turntable Stretch Wrapper close to an area where you will be wrapping
your loads. Make sure that there is sufficient room to load/unload the machine and that you
do not stretch the power cable. Remember, you will need to plug the machine in to a
120VAC, 15-Amp outlet.
Floor Weight Bearing/Stress Tolerance
The floor must be able to bear the weight of the machine, the weight of the maximum load,
plus a safety factor. The floor must also be able to tolerate the stress of the machine’s
operation. If the fork trucks will operate on the same weight bearing area, add the weight of
the trucks to the weight bearing stress tolerance requirements.
The Synergy can be installed on any type of floor constructions that meets the weight
bearing and stress tolerance requirements.
Warning!
The Synergy must be anchored securely to the floor, using the type of anchor
recommended for your floor.
Machine Placement
