High End Systems studio color, User Manual

Page: 91 / 114

Appendix B Accessory Installation B-7
Introduction
Acce
ss
ory
Inst
allation
B
Accessory Lens Installation
To complete this procedure, you will need the following items:
• accessory lens
• phillips screw driver
Complete the following procedure to install an accessory lens:
1. Remove power from the fixture and place it on a flat surface.
2. Remove the bezel by releasing the two latches located in the middle of the
head. Refer to Figure B.1.
3. Remove the safety cable from its latch and set the bezel on a flat surface.
4. Using a phillips-head screw driver, loosen the four screws securing the clips to
the lens and rotate the clips 90°. Refer to Figure B.7.
Figure B.7. Lens Removal
5. Remove the old lens and install the new lens in its place.
6. Rotate the clips back in place and tighten the four screws. Check to ensure the
lens is secure by attempting to rotate it.
7. Reinstall the bezel, attach the safety clip, and relatch the bezel.
Note: the bezel can only be correctly replaced one way to allow the use of the safety
cable.
remove these
screws (4)