HES HS2510-N, User Manual

Page: 63 / 64

61
Hwang Sun Enterprise Co., Ltd.
61 Edition 2012/02
TECO Parameters Setting of CV Series
＊
Please adjust item to “3-17” and change the parameter into “0000” for unlocking
Item Description Parameter Statement
0-00 Control Mode 0002 Volts / Hz (Refer to Parameter
Group 10 – Volts / Hz Mode)
0-01 Motor Rate Voltage ( Vac ) 220.0
0-02 Motor Rate Current ( Amp) 002.4
0-03 Motor Rate Power ( KW ) 000.4
0-05 Motor Rate Frequency ( Hz ) 060.0
1-00 Run Command Source 0001 External Run/Stop Control
1-01 Run / Stop-Forward / Reverse
Operation Mode with External
Terminals
0000 Forward / Stop
Reverse / Stop
1-02 Prohibition of Reverse
Operation
0001 Disable Reverse Command
1-03 Keypad Stop Button 0001 Stop Button Disabled
1-05 Stopping Method Selection 0000 Controlled Deceleration-to-Stop
with DC Injection Braking (Rapid
Stop)
1-06 Frequency Command Source
Selection
0000 Keypad
2-00 Momentary Power Loss and
Restart
0001 Momentary power loss and restart
enable
2-03 Number of Auto Restart
Attempts
0002
3-00 Frequency upper Limit 60.0
Modify according to the actual
operation
3-02 Acceleration Time #1 (Seconds) 10.0 (sec) Modify according to the actual
operation
3-03 Deceleration Time #1 (Seconds) 10.0 (sec) Modify according to the actual
operation
3-12 DC Injection Break Time 000.0 (sec)
4-00 Motor Current Display
Selection
0001 Enable motor current display
9-09 Motor Type Selection 0001 Electronic Motor Overload
Protection Set for Inverter Duty
Motor
9-12 Over torque Detection Selection 0002 Enable Over torque Operation
while the Drive is in Run Mode
9-13 Operation Over torque
Detection is Activated
0001 Cosat-to-Stop After Over torque is
Activated
9-14 Over torque Threshold Level
(%)
0135
Modify according to the actual
operation
10-0 Volts / Hz patterns 0009/0000 ( 60 / 50Hz)
10-2 Motor No Load Current (Amps
AC)
001.0 ( F0 – 02 *0.4 )
10-4 Maximum Frequency (Hz) 60.0/50.0 All parameter are read-only.
Please adjust item to “3-17” and change the parameter into“0003” for lock.