HES HS2510-N, User Manual

Page: 25 / 64

23
Hwang Sun Enterprise Co., Ltd.
23 Edition 2012/02
3.Check the tank level and add adhesive
material as necessary.
4.Check the temperatures of all systems
of the applicator to the required
temperature and other recommended
value.
If not, refer to chapter3.2 to re-set the
temperatures.
5.After all parts temperature reach the
individual setting point and the adhesive
material in the tank becomes molten, turn
on the power of the motor.
Note:
If the indicator “PASS THE MOTOR
START” not light, please check if the air
pressure below the range of air pressure
detector (green indicator), and adjust the
air pressure as the instruction on chapter
3.3.
6.Inspect the air pressure of the nozzle
device is in the setting range
(2.5 ~ 4Kg/cm
2
)