Heras HGD230, User Manual

Page: 76 / 146

EN – Translation of the original user manual - 2.1 | 2019 76
7.11.2 Time to close from Part OPEN position
The motor drive can close the gate automatically after a set time (1 to 255
seconds) has elapsed after the Part OPEN position was reached. This function is
active only in automatic mode and after the Part OPEN position has been reached.
•
Menu: "Settings", "Set timer", "Keep-Part OPEN TMR": set to "xxx".
Example: If the "Keep Part OPEN TMR" parameter is set at value 5, a 5-second
timer is started when the gate reaches its Part OPEN position in automatic mode.
This timer causes the gate to be closed automatically again after 5 seconds. If
another Part OPEN command is given or there is a static Part OPEN command
during this time, the timer will start to count down again.
This value can be changed by the customer without the need to enter a password.
Attention! If a TMR AUTOMATIC CLOSING IS SET and the gate is in the
OPEN position and the control is restarted (for example, by interrupting
the voltage), THE TMR AUTOMATIC CLOSING IS ALSO RESTARTED. After the
countdown of the timer, the gate will be closed automatically.
7.11.3 Time to close the gate from interim positions
If the gate always has to close again automatically by itself (automatic closing
movement) after a set time (1 - 255 seconds), this must be set via the "TMR Auto
Close" parameter. This function is only active in automatic mode and concerns all
gate positions except the OPEN end position and the Part OPEN position.
•
Menu: "Service Menu", "Enter passw.": enter the password.
•
Menu: "Settings", "Set timer", "Auto Close TMR": set to "xxx".
Example: If the time is pre-set at 20, a 20-second timer is started as soon as the
motor stops in automatic mode (other than by the STOP key being pressed) and
the gate is not in the CLOSED end position. This timer causes the gate to be
closed automatically again after 20 seconds.