Heras HGD230, User Manual

Page: 66 / 146

EN – Translation of the original user manual - 2.1 | 2019 66
• Press the CLOSED button. The motor drive determines the maximum
motor running time
and saves it.
A reference run is now performed to lay down the maximum motor running times
for moving from one end position to the other end position. The reference run
consists of the gate moving automatically all the way from the OPEN position to
the CLOSED position at low speed once. The motor drive measures the time that
elapses during this reference run and save this time to its memory. The motor
drive is ready for use now.
Check that both end positions are reached and that the motor stops when these
end positions have been reached.
If values have been ‘taught’ incorrectly, all values can be cleared at once by
selecting "Settings", "End positions", "RESET pos.". The total teaching procedure
has to be repeated then.
Attention: Teaching the end positions must always start by teaching the
CLOSED position. Other entry sequences will not be accepted.
Attention: If the gate has been disconnected from the motor drive control
system and has been moved by hand, the gate position will no longer be
defined in the software. You must then manually move the gate to its
CLOSED position and set the position again.
Attention: If there is a power failure while the gate is being moved, it may
no longer be possible to save the gate position. This is indicated by the fact
that the gate can no longer be moved in automatic mode. You must then also
manually move the gate to its CLOSED position and set the position again.
Procedure:
•
Move the gate into the CLOSED position.
•
Press "Settings", "End positions", "Set CLOSED pos.". The motor drive
performs a reset.
•
Check that both end positions are reached and that the motor stops when
these end
positions have been reached.