Heras HGD230, User Manual

Page: 80 / 146

EN – Translation of the original user manual - 2.1 | 2019 80
• Connect the device to the desired Rel4 or Rel5 output.
• Menu: "Service Menu", "Enter passw.": enter the password.
• Menu: „Settings“, „In/Outputs“, „OUT Rel4“ or „OUT Rel5“: set to a
value from the above table.
•
Exit menu and test function.
7.17 SAVING PARAMETERS TO THE MEMORY
The operating parameters can also be saved in a special section of the memory. A
copy of the current parameter settings is then made and these settings as saved
can be restored later, overwriting the, then, current parameters.
7.17.1 Saving the parameter settings
You can make a backup copy of the current operating parameter settings of the
motor drive and save this to a separate part of the memory. If the parameter
settings are changed later and found not to be OK, you can restore the previously
saved parameter settings so that the parameters are correct again.
•
Menu: "Service Menu", "Enter passw.": enter the password.
•
Menu: "Settings", "Param Backup", activate "Save new".
7.17.2 Restoring parameter settings
You can reactivate the backup copy of the motor drive operating parameter
settings that has been saved in a separate part of the memory to use these
settings again as the current operating parameters. This enables the saved
(operational) parameters to be restored after a faulty configuration of the
HMD230.
•
Menu: "Service Menu", "Enter passw.": enter the password.
•
Menu: "Settings", "Param Backup", activate "Restore".
•
When copying has ended, the software will automatically restart the
master drive with the restored parameters.
7.18 SAVING PARAMETERS TO CHIPCARD
A chipcard reader interface can be connected to the communication slot of the
motor drive. This card reader enables standard I2C chipcards to be read and to be
written to 64-kByte memory cards are supported.