Heras HGD230, User Manual

Page: 81 / 146

EN – Translation of the original user manual - 2.1 | 2019 81
Illustration 38: Chipcard reader
7.18.1 Saving the parameter settings to card
The communication with the chipcard reader interface to write the parameter
settings from the HMD230 to a card only works in combination with the installed
LCD screen.
The parameters are written to the card as follows:
• Menu: "Service Menu", "Enter passw.": enter the password.
• Menu: "Settings", "Param Backup", activate "Write card".
• The text "copy CTRL->Card." is displayed; when the procedure has
ended,
the message "Card writing ready" is displayed.
•
You can now remove the card to which data has been written and which
has been checked from the card reader.
Attention! : If a chipcard reader is not connected or if errors occur
during copying the following message is displayed: "Card Comm.
ERROR". If such an error occurs while writing to the memory on the
chipcard, the data on the card in question must not be used anymore. You
can either write the data to the card again, or format the card on another
writing/reading device or destroy the card.
7.18.2 Reading the parameter settings from the card
The contents of chipcards can only be copied to the motor drive if a correctly
written chipcard is recognised in the chipcard reader interface when switching on
the motor drive (restart and/or reset).