Heras HGD230, User Manual

Page: 72 / 146

EN – Translation of the original user manual - 2.1 | 2019 72
message in the control system is met, the flash light remains active for a few
seconds after each movement to the end position of the door (the flash light does
not go off until 4, 8 or 12 seconds after the engine has stopped).
The additional activation of the maintenance message is done in the following
way:
•
Menu: "Service Menu", "Enter passw.": enter the password.
•
Menu: „Settings“, „Spec.parameter“, „Service action“: set 0 up to 3
The following actions are linked to the set value:
Parameter
value Flash light function
0 No futher flash light function
1 Flash light remains on for 4 seconds longer after the OPEN or
CLOSE position has been reached
2 Flash light remains switched on for 8 seconds longer
3 Flash light remains switched on for 12 seconds longer
7.8.5 Maintenance message on a relay output
The HMD230 can be set so that an active maintenance message also activates a
relay for signaling. This function can be set to Rel4 or Rel5. By way of example,
the setting for Rel5 is described here. Contacts can also be connected to the
backplane; see appendix B and C.
•
Switch off the power supply to the motor drive.
•
Connect signal light to relay output Rel5
•
Switch on the power supply to the motor drive.
•
Menu: "Service Menu", "Enter passw.": enter the password.
•
Menu: „Settings“, „In/Outputs“, „OUT Rel5“: set to „6“.
The lamp connected to "Rel5" is now switched on by the controller as soon as one
of the set maintenance messages becomes active.