Heras HGD230, User Manual

Page: 35 / 146

EN – Translation of the original user manual - 2.1 | 2019 35
5.5 LCD SCREEN
An LCD screen with two lines of 16 characters each has been provided to display
more motor drive control information. This shows the active operating mode of
the motor drive or the movement status of the motor in legible text.
The background of the display is lit for as long as the twist and selector switch is
operated. 20 seconds after the last entry is made, the light is switched off. It can
be switched on again at any moment by turning the selector switch. The display is
also properly legible in direct sunlight.
Heras HMD230S
Automatic Mode Heras HMD230A
Automatic Mode
Illustration 20: Information on the LCD screen
After resetting the software or after switching on the power, the display light
will blink for a few seconds. This indicates that the processor is booting; it is
not a fault condition.
5.5.1 Display of operating modes
The following options are available as regards displaying operating modes on the
LCD screen:
Display reading Meaning
ATC Pe:x.xx
Start indication of the periphery controller
(wait for information from the motor controller)
Heras HMD230
Automatic mode Automatic operating mode, the gate is now in the idle
position
Automatic mode
Open
Automatic mode; gate opening active
Automatic mode
Close
Automatic mode; gate closing active
Automatic mode
Stop immediately
Automatic mode; STOP active
Automatic mode
Close: xx Automatic mode; the gate closes automatically after
XX seconds
Heras HMD230
Hold-to-run-
Idle position for hold-to-run-control
Hold-to-run-
control
Open gate in hold-to-run-control mode active