Heras HGD230, User Manual

Page: 19 / 146

EN – Translation of the original user manual - 2.1 | 2019 19
3.2.2 Closing the cover
• Lower the tabs of the cover into the slot in the
drive unit cabinet.
•
Screw the cover into place to close it. Make sure
that the sides of the cover properly fit over the
drive unit cabinet.
•
Close the lever and the lock.
Illustration 6: closing the cover*
* The illustration shows the HMD230. The same principle applies to the HGD230
and IGD230.
3.2.3
Open / close in case of emergency
Two push buttons are located on the backplane of the control unit. These can be
used to open, close and stop the gate.
Illustration 7: Backplane
• OPEN:
Press the "Open" button. The gate slides open to the next end
position. This can be completely or
partially open (if the “Partially open”
function has been programmed).
• CLOSE:
Press the "Close" button. The gate closes completely.
•
STOP:
Press the “Open” and Close”
buttons* simultaneously. The gate will stop immediately,
irrespective of its direction of travel.
Press “Open” or "Close" to restart the
gate.