Henny Penny LVE-202, Technical Manual

Page: 57 / 115

Maintenance
45
2 2))
Form inside of control area, squeeze in on tabs on back of switch and push
switch out the front of control area.
3 3))
Label and remove wires from switch.
7 7..8 8..1 1 C Ch he ecckko ou utt
1 1))
Check across two sets of switch terminals for continuity. With switch in on
position, circuit should be closed. With switch in off position, circuit should be
open. If the switch is found to be defective, replace it by connecting the wires to
new switch (as labeled) and push switch into place.
7 7..9 9 T Te em mp pe erra attu urre e P Prro ob be e R Re ep plla acce em me en ntt
The temperature probe relays the actual shortening temperature to the control. If it
becomes disabled, “E-6” will show in the display. Also, if temperature is out of
calibration more than 10°F or 10°C, the temperature probe should be replaced.
7 7..9 9..1 1 C Ch he ecckko ou utt
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
1 1))
Support control panel bottom with one hand, loosen retaining screw at panel
top, slide panel down slightly to clear screw, push panel bottom up, then swing
panel top out and down.