Henny Penny LVE-202, Technical Manual

Page: 42 / 115

Level
3
Programming
30
Program Code Description
• Press product 7 to open and close the return valves.
“DcRc” means valves are closed, “DoRo” means valves are open
(driven by the control board).
2 2.. Press the down arrow and “DISCARDc” and “JIBFILLc” shows in
the displays (driven by the AIF board).
• Press product 1 to open and close the RTI discard valve
(display shows “DISCARDo” when open.
• Press product 2 to open and close the RTI JIB fill valve
(displays shows “JIBFILLo) when open.
3 3.. Press the down arrow and “SEL-VALV” “AT HOME” shows in the
displays.
• Press product 2 and “REV, CNT” “HOM, POS” followed by
actual data values such as “3.19R 10P” “14.4° 15.2°”. One
revolution of the valve took 3.19 seconds, counted 10 ports
during revolution, the dwell angle of the home switch was 14.4°,
and the dwell angel of the position switch was 15.2°.
• Press product 3 and “CALIBRAT” “AT HOME” show in the
displays. Press ✓ to request a calibration, data values as above
will appear in the display.
• Press product 4 and “NEXT POS” “AT HOME” shows in the
display. Press the left ✓; valve moves to next port position.
• Press product 5 and “CONT RUN” “AT HOME” show in the
displays. Press the left ✓; valve will run continuously until you
press the stop button.
• Press product 6 and “RAW✓MTR_” “D✓HxP*” shows in the
display. The ✓ indicates a signal was constantly on, the “_”
means a signal was constantly off, and the “X” means the
signal was both on and off.
4 4.. Press the down arrow and “PUMP FP_” “JP_NP_” shows in the
display (driven by the AIF board).
• Press product 1 to turn off and on the filter pump (display
shows “FP*” when on).
• Press product 2 to turn off and on the JIB pump (display shows
“JP*” when on).
• Press product 3 to turn off and on the RTI new oil pump (display
shows “NP*” when on).
5 5.. Press the down arrow and “LIGHTS” “FLT_ JLO_” shows in the
display (driven by the AIF board).
• Press product 1 to turn off and on the filter light (display shows
“FLT*” when on).