Henny Penny LVE-202, Technical Manual

Page: 56 / 115

Maintenance
44
7 7..7 7..2 2 R Re ep plla acce em me en ntt
1 1))
Open left door.
2 2))
Using a 9/16 inch wrench, remove retaining nut from below and remove breaker
from controls area.
3 3))
Install new breaker in reverse sequence.
4 4))
Support control panel bottom with one hand, swing panel top up about 90
degrees, slide panel down slightly to clear screw head, push panel top up to
engage screw, then tighten screw.
7 7..8 8 M Ma aiin n P Po ow we err S Sw wiittcch h
This is a covered rocker switch, which in the on position sends power to all the
controls and filter motor. However, in some installations, one pair of contacts may be
used to control an exhaust hood fan.
S SH HO OC CK K H HA AZ ZA AR RD D T To o a avvo oiid d e elle eccttrriicca all
ssh ho occkk,, m mo ovve e tth he e p po ow we err ssw wiittcch h tto o o offff a an nd d
d diisscco on nn ne ecctt m ma aiin n cciirrccu uiitt b brre ea akke err,, o orr u un n--
p pllu ug g cca arrd d a att w wa allll rre ecce ep ptta acclle e..
1 1))
Support control panel bottom with one hand, loosen retaining screw at panel
top, let panel slide down slightly to clear screw, push panel back up, then switch
panel top out and down.