Henny Penny LVE-202, Technical Manual

Page: 66 / 115

Maintenance
54
3 3))
Use Philip’s-head screwdriver and 5/16 inch nut driver to remove two screws
and nuts securing the switch.
4 4))
Reassemble with new switch, making sure switch lever is inside hole of element
sense arm and the switch is actuated, and then reconnect wires to the switch.
5 5))
Reinstall rear shroud.
6 6))
Reconnect P9 or P10.
7 7))
Support control panel bottom with one hand, swing panel top up about 90
degrees, slide panel down slightly to clear screw, push panel up to engage
screw, and tighten screw.
7 7..1 12 2 C Co on ntta acctto orrss
The open fryer requires two switching, 24V contactors per vat: a primary (2) and a
heat contactor (1) (see
7.12 Contactors, page 54 ). The primary contactor energizes
(contacts close) any time the main power switch is in the ON position, and the
temperature of the shortening is below 420°F (215°C). The high temperature limit
module cuts power at the primary contactor if the temperature of the shortening is
above 420° F ( 215° C). The primary contactor supplies power to one side of the heat
contactor. The heat contactor is controlled by the computer controller. When the heat
button is pressed and the controller calls for heat, the heat contactor applies power to
the heating elements. When the heat contactor and primary contactor are energized
(contacts closed), electric heating elements heat the shortening.