Haulotte HTL4014, Operator'S Manual

Page: 61 / 194

A
B
C
D
E
F
G
H
I
55
2420331560 E 04 07 GB
TELESCOPIC HANDLERS
D
- OPERATION
• Never operate the telehandler without a proper and legible capacity chart displayed in the
operator's cab for the telehandler/attachment combination in use.
2.3 - TRANSPORTING THE LOAD
Once the load is engaged on the forks and leaning against the fork carriage, tilt the load backwards
to place it in the travel position. Travel as specified in Section A and Section E.
2.4 - DUMPING PROCEDURE
• Position the machine in the best location for lifting or placing the load.
• Actuate the parking/service brake and shift the gear control lever to NEUTRAL.
• Move the boom/attachment with less 30°.
• Observe the level indicator to determine whether the machine must be leveled and level the
machine with the switch (P200).
The machine is designed to allow movement of the main chassis 10° forward and backwards.
2.5 - PLACING THE LOAD
Before placing a load :
• Ensure that the unloading point can safely support the weight of the load.
• Ensure that the unloading point is level, both lengthways and sideways.
• Use the capacity chart to determine the permitted boom extension range.
• Lower the forks to the level at which the load must be placed, and then extend the boom slowly
until the load is just above the area where it must be placed.
• Lower the boom until the load rests in position and the forks can be retracted.
Never raise the boom/attachment more than 1.2m above the ground unless the machine is leveled. The
combination of sideways movement and the load could cause the machine to tip over.