Haulotte HTL4014, Operator'S Manual

Page: 60 / 194

54
2420331560 E 04 07 GB
TELESCOPIC HANDLERS
• Remove the ignition key.
• Exit the machine correctly.
• Block the wheels if necessary.
2 - Use with a load
2.1 - LOAD LIFTING SAFETY
• Know the weight and the centre of gravity of each load to be lifted.
• Use the load capacity chart associated with each equipment.
You should know the machine's rated load capacities (see Section G Technical Specifications) to
determine the operating range within which you can safely lift, transport and place loads.
2.2 - BEFORE LIFTING A LOAD
• Check the ground conditions. Adapt the travel speed and reduce the load weight according to the
ground.
• Avoid lifting unbalanced loads.
• Make sure that there are no obstacles near the load.
• Adjust the fork spacing so that they engage into the pallet or under the load at maximum width and
remain centred on the fork carriage.
• Face the load and approach it slowly with the fork tips straight and horizontal. Never attempt to lift
a load with just one fork.
The cab seat is equipped with an operator presence detection system. The LED (P195) lights. If the
operator leaves the seat when the machine engine is operating, after an 8-second time delay, the
presence detector deactivates travel and automatically actuates the parking brake.
Remain correctly seated during movement. Otherwise, the machine may brake suddenly.
Exceeding the machine's lifting capacity may damage the equipment and/or cause tipping
over, resulting in death or serious injury.
Never lift any loads if a correct and legible capacity chart corresponding to the accessory usedis not
displayed in the operator's cab.