Maintenance
2G40, 2G40 H
62
HATZ
Operator’s Manual
5
Seal ring
6
Level mark
7
Filter housing
8
Filter insert
9
Gasket package
Procedure
Step
Activity
1
Remove the oil container (1).
2
Remove the dirty oil and sludge, and clean the container.
3
Remove and clean the rain cap (2) or cyclone precleaner (3).
4
Clean through the intake pipe (4).
5
Check the gasket (5) and renew if necessary.
6
In case of heavy contamination, remove the filter housing (7)
from the engine and rinse it in diesel fuel.
7
Before assembling the filter, allow to thoroughly drip off or wipe
off the diesel fuel.
8
Check the filter housing before mounting. If the sealing surface
is uneven, or there are cracks in the filter housing or filter wool is
missing, do not use the filter, rather replace it by a new filter.
9
Install the filter housing using a new gasket package (9).
10
Fully assemble the filter and prepare it for operation by filling it
with oil (see chapter
6.5 Filling the oil bath air filter (option),
).
8.2.7
Checking and setting the tappet clearance
Safety note
CAUTION
Danger of burns.
There is a danger of burns when working on a hot engine. Only
perform the settings while the engine is cold (10-30°C).
▪
Let the engine cool.
